Stellar structure
Stellar atmospheres
To interpret a stellar spectrum quantitatively, knowledge of the variation in temperature and density with depth in the star’s atmosphere is needed. Some general theoretical principles are outlined here.
The gradient of temperature in a star’s atmosphere depends on the method of energy transport to the surface. One way to move energy from the interior of a star to its surface is via radiation; photons produced in the core are repeatedly absorbed and reemitted by stellar atoms, gradually propagating to the surface. A second way is via convection, which is a nonradiative mechanism involving a physical upwelling of matter much as in a pot of boiling water. For the Sun, at least, there are ways of distinguishing the mechanism of energy transport.
Photographs of the Sun’s disk show that the centre of the disk is brighter than the limb. The difference in brightness depends on the wavelength of the radiation detected: it is large in violet light, is small in red light, and nearly vanishes when the Sun is imaged in infrared radiation. This limb darkening arises because the Sun becomes hotter toward its core. At the centre of the disk, radiation is received from deeper and hotter layers (on average) instead of from the limb, and the dependence of temperature on depth can be shown to correspond to the transport of energy by radiation, not by convection, at least in the outer layers of the Sun’s atmosphere.
The amount of limb darkening in any star depends on the effective temperature of the star and on the variation in temperature with depth. Limb darkening is occasionally an important factor in the analysis of stellar observations. For example, it must be taken into account to interpret properly the observed light curves of eclipsing binaries, and here again the results suggest transport of energy via radiation.
The layers of a normal star are assumed to be in mechanical, or hydrostatic, equilibrium. This means that at each point in the atmosphere, the pressure supports the weight of the overlying layers. In this way, a relation between pressure and density can be found for any given depth.
In addition to the temperature and density gradients, the chemical composition of the atmospheric layers as well as the opacity of the material must be known. In the Sun the principal source of opacity is the negative hydrogen ion (H−), a hydrogen atom with one extra electron loosely bound to it. In the atmospheres of many stars, the extra electrons break loose and recombine with other ions, thereby causing a reemission of energy in the form of light. At visible wavelengths the main contribution to the opacity comes from the destruction of this ion by interaction with a photon (the above-cited process is termed photodissociation). In hotter stars, such as Sirius A (the temperature of which is about 10,000 K), atomic hydrogen is the main source of opacity, whereas in cooler stars much of the outgoing energy is often absorbed by molecular bands of titanium oxide, water vapour, and carbon monoxide. Additional sources of opacity are absorption by helium atoms and electron scattering in hotter stars, absorption by hydrogen molecules and molecular ions, absorption by certain abundant metals such as magnesium, and Rayleigh scattering (a type of wavelength-dependent scattering of radiation by particles named for the British physicist Lord Rayleigh) in cool supergiant stars.
At considerable depths in the Sun and similar stars, convection sets in. Though most models of stellar atmospheres (particularly the outer layers) assume plane-parallel stratified layers, photographs of granulation on the Sun’s visible surface (see Sun: Photosphere) belie this simple picture. Realistic models must allow for rising columns of heated gases in some areas and descent of cooler gases in others. The motions of the radiating gases are especially important when the model is to be used to calculate the anticipated line spectrum of the star. Typical gas velocities are on the order of 2 km (1.4 miles) per second in the Sun; in other stars they can be much larger.
Temperature, density, and pressure all increase steadily inward in the Sun’s atmosphere. The Sun has no distinct solid surface, so the point from which the depth or height is measured is arbitrary. The temperature of the visible layers ranges from 4,700 to 6,200 K, the density from about 10−7 to 4 × 10−7 gram per cubic cm, and the gas pressure from 0.002 to 0.14 atmosphere. The visible layers of stars such as the Sun have very low densities and pressures compared with Earth’s atmosphere, even though the temperature is much higher. The strata of the solar atmosphere are very opaque compared with the terrestrial atmosphere.
For stars other than the Sun, the dependence of temperature on depth cannot be directly determined. Calculations must proceed by a process of successive approximations, during which the flux of energy is taken to be constant with depth. Computations have been undertaken for atmospheres of a variety of stars ranging from dwarfs to supergiants, from cool to hot stars. Their validity can be evaluated only by examining how well they predict the observed features of a star’s continuous and line spectrum, including the detailed shapes of spectral-line features. Considering the known complexities of stellar atmospheres, the results fit the observations remarkably well.
Severe deviations exist for stars with extended and expanding atmospheres. Matter flowing outward from a star produces a stellar wind analogous to the solar wind, but one that is often much more extensive and violent. In the spectrum of certain very hot O-type stars (e.g., Zeta Puppis), strong, relatively narrow emission lines can be seen; however, in the ultraviolet, observations from rockets and spacecraft show strong emission lines with distinct absorption components on the shorter wavelength side. These absorption features are produced by rapidly outflowing atoms that absorb the radiation from the underlying stellar surface. The observed shifts in frequency correspond to ejection velocities of about 100 km (60 miles) per second. Much gentler stellar winds are found in cool M-type supergiants.
Rapid stellar rotation also can modify the structure of a star’s atmosphere. Since effective gravity is much reduced near the equator, the appropriate description of the atmosphere varies with latitude. Should the star be spinning at speeds near the breakup point, rings or shells may be shed from the equator.
Some of the most extreme and interesting cases of rotational effects are found in close binary systems. Interpretations of the light and velocity curves of these objects suggest that the spectroscopic observations cannot be reconciled with simple orderly rotating stars. Instead, emission and absorption lines sometimes overlap in such a way as to suggest streams of gas moving between the stars. For example, Beta Lyrae, an eclipsing binary system, has a period of 12.9 days and displays very large shifts in orbital velocity. The brighter member at visible wavelengths is a star of type B6–B8; the other member is a larger, early B-type star that is embedded in an accretion disk and is draining matter from the B6–B8 star. The spectrum of the B6–B8-type component shows the regular velocity changes expected of a binary star, but there is an absorption (and associated emission) spectrum corresponding to a higher temperature (near spectral type B5) and a blue continuum corresponding to a very high-temperature star. The anomalous B5-type spectrum is from the accretion disk and is evidently excited principally by the star within it. This spectrum shows few changes in velocity with time.
Supergiant stars have very extended atmospheres that are probably not even approximately in hydrostatic equilibrium. The atmospheres of M-type supergiant stars appear to be slowly expanding outward. Observations of the eclipsing binary 31 Cygni show that the K-type supergiant component has an extremely inhomogeneous, extended atmosphere composed of numerous blobs and filaments. As the secondary member of this system slowly moves behind the larger star, its light shines through larger masses of the K-type star’s atmosphere. If the atmosphere were in orderly layers, the lines of ionized calcium, for example, produced by absorption of the light of the B-type star by the K-type star’s atmosphere, would grow stronger uniformly as the eclipse proceeds. They do not, however.